I have a few doilies laying on a shelf hidden in stuff. So I thought - I need to put them on display but not old-fashioned way. I ended up with three DIYs - luminary, basket/bowl and cushion cover.
All are so cute and pretty, I am glad that I finally made them.
Now let me tell you how to make them.
#1 Luminary
This one must be the quickest and the easiest one.
For this you will need:
#2 Basket
For this DIY you will need:
I lied my doily on the small bucket but it could be a bowl, a jar or anything in shape you like/want your doily basket to be.
Even out all bumps because when it all dries it will stay in that shape.
Because of the pattern of my doily, I pulled up the ends of it so that they would be a bit curvy instead of flat and sharp.
Let it dry completely, preferably overnight.
It came off the bucket very easy. I was scared that it will stick but actually, it came off without any effort.
#3 Cushion cover
For this DIY you will need:
Pin all in place (try to pin only to the top layer of the cushion cover).
When that is done stitch them to the cushion cover.
I did pretty light stitches avoiding them to show up.
Also check out the video tutorial:
All are so cute and pretty, I am glad that I finally made them.
Now let me tell you how to make them.
#1 Luminary
This one must be the quickest and the easiest one.
For this you will need:
- a doily
- a jar
- a ribbon
- a safety pin
- a flameless candle
The doily and the jar should "match" the size. One of them should not be too big/small - just place the jar in the middle of the doily and then lift the sides of the doily to see how it looks.
If you like how it looks - check where to thread a ribbon in a doily (ribbon should go around the jar's neck).
Using a safety pin thread the ribbon around the edge at the measured distance from the center/edge.
After threading around the full circle the doily will look like a hat.
Both ends of the ribbon should be outside the "hat" and the same length.
Put the jar in the middle.
Pull both ends of the ribbon to close the "hat/sack".
Place the ribbon around the jar's neck and tighten.
Make sure everything lies evenly.
Tie the ribbon in a bow.
Place a flameless candle inside.
#2 Basket
For this DIY you will need:
- a doily
- white glue
- a bowl
Put a doily in a bowl with some white glue (or 1:1 white glue and water mixture).
Soak it completely, make sure that it is all covered in glue (add some more if needed).I lied my doily on the small bucket but it could be a bowl, a jar or anything in shape you like/want your doily basket to be.
Even out all bumps because when it all dries it will stay in that shape.
Because of the pattern of my doily, I pulled up the ends of it so that they would be a bit curvy instead of flat and sharp.
Let it dry completely, preferably overnight.
It came off the bucket very easy. I was scared that it will stick but actually, it came off without any effort.
#3 Cushion cover
For this DIY you will need:
- a cushion cover
- a doily
- some felt or fabric scraps
- scissors
- a thread and a needle
- pins
Take a piece of felt and cut out a flower stem and leaves.
Place the doily and the felt details on the cushion cover creating a flower.Pin all in place (try to pin only to the top layer of the cushion cover).
When that is done stitch them to the cushion cover.
I did pretty light stitches avoiding them to show up.
Also check out the video tutorial:
Be pretty!
xxx
J.M.
No comments:
Post a Comment